Filter
Top Products
P100IH ISDN Router
Remote Node Configuration 5-9
5.1.7 Remote Node Filter
Use Menu 11.5 – Remote Node Filter
to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and to prevent certain packets from triggering calls. You
can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each
filter
field.
Note that spaces are accepted in this field. For more information on defining the filters,
see Chapter 9:
.
The Prestige comes with a prepackaged filter set, NetBIOS_WAN, that blocks NetBIOS packets (call
protocol filter = 1). You can include this in the call filter sets if you wish to prevent NetBIOS packets from
triggering calls to a remote node.
Figure 5-4 Menu 11.5 – Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters
=
Enter here to CONFIRM or ESC to CANCEL: