Filter
Top Products
ExpWave 240B Secure Outdoor Ethernet Radio Link
Initial Setup 3-7
At this point, you should have connected the console port, the RF (Antenna) port, the LAN port, and the power port to
the appropriate devices or lines. While connecting power adaptor into outlet, the PWR LED of your Network/Power
injector turns on. The ACT LED of Network/Power injector turns on while the outdoor radio unit operates well.
3.2.1 Initial Screen
When you turn on your ExpWave, it performs several internal tests as well as line initialization. After the tests, the
ExpWave display as follow, you can press [ENTER] to continue, as shown next.
Figure 3-17 Initial Screen
3.2.2 Entering the Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown below.
For your first login, enter the default password “1234”. As you type the password, the screen displays an (X) for each
character you type.
Please note that if there is no activity for longer than five minutes after you log in, your ExpWave will automatically log
you out and display a blank screen. If you see a blank screen, press [ENTER] to bring up the login screen again.
Figure 3-18 Password Screen
3.3 Navigating the SMT Interface
The SMT (System Management Terminal) is the interface that you use to configure your ExpWave.
Several operations that you should be familiar with before you attempt to modify the configuration are listed in the
table below.
Table 3-2 Main Menu Commands
OPERATION KEYSTROKES DESCRIPTION
Move down to
another menu
[ENTER] To move forward to a submenu, type in the number of the desired
submenu and press [ENTER].
Move up to a
previous menu
[ESC] Press the [ESC] key to move back to the previous menu.
Move to a
“hidden” menu
Press [SPACE BAR] to
change No to Yes then
press [ENTER].
Fields beginning with “Edit” lead to hidden menus and have a default
setting of No. Press [SPACE BAR] to change No to Yes, then press
[ENTER] to go to a “hidden” menu.
Move the cursor [ENTER] or
[
UP
]
/
[
DOWN
]
arrow
Within a menu, press [ENTER] to move to the next field. You can
also use the
[
UP
]
/
[
DOWN
]
arro
w
ke
y
s to move to the
p
revious and
Enter Password : XXXX
Copyright (c) 1994 - 2002 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:02:CF:95:18:51
initialize ch =1, v2.5/3.0 card OK. ethernet address: 00:02:CF:95:18:52
adjust TCP mss on enif0 to 1400