Filter
Top Products
9–9
+ &P0 Pulse dial make/break ratio= 39%:61%. (Default)
&P1 Pulse dial make/break ratio= 33%:67%.
&R0 CTS tracks RTS, response delay is set in S26.
+ &R1 The modem assumes that RTS is always ON, ignores the changes.
(Default)
+ &S0 The modem forces DSR to always remain ON. (Default)
&S1 DSR according to ITU-T. If S44.4=1, DSR follows DTR. If
S41.5=1, DSR is always on, but follows CD off for 0.5 second.
&T0 Terminates test in progress.
&T1 Initiates Analog LoopBack (ALB) test.
&T2 Reserved.
&T3 Initiates Local Digital Loopback (LDL) test.
&T4 Grants Remote Digital Loopback request from the remote modem.
+ &T5 Denies Remote Digital Loopback request from the remote modem.
(Default)
&T6 Initiates Remote Digital Loopback (RDL) test.
&T7 Initiates Remote Digital Loopback with self test (RDL+ST).
&T8 Initiates Analog LoopBack with self test (ALB+ST).
&V0 Views current active settings.
&V1 Views user profile 0 settings.
&V2 Views user profile 1 settings.
&V3 Views user profile 2 settings.
&V4 Views user profile 3 settings.
&V5 Views factory default settings.
&W0 Saves current settings to user profile 0. (See also S35b6)
&W1 Saves current settings to user profile 1.
&W2 Saves current settings to user profile 2.
&W3 Saves current settings to user profile 3.
+ &X0 The modem provides synchronous transmit clock signal. (Internal
clock to pin 15 of EIA-232D.) (Default)
Note: &Rn controls the synchronous mode operation only. In asynchro-
nous mode, CTS/RTS are used for flow control.