Filter
Top Products
9–12
*M1 Leased-line auto-handshake on answer mode.
*P0-15 Sets leased-line transmission power level, range from 0 dBm to
-15 dBm (Default = -9 dBm); range from -12 dBm to -27 dBm if
S35b3 is set. The maximum transmission power for Omni 288P
and 288S is -9dBm and -3dBm, respectively.
*Q0 No action to poor signal quality.
*Q1 Retrain action taken if signal quality is poor.
+ *Q2 Adaptive rate; auto fall-back or fall-forward. (Default)
*Q3 Disconnect for poor signal quality.
*Rab Read remote profile b to local profile a:
a= 0-3, local user profile number.
b= 0-3, remote user profile number.
4, remote active configuration.
5, remote factory default.
+ *S0 Secondary channel disabled. (Default)
*S1 Secondary channel enabled.
*T Displays last caller ID message.
*V Views password table.
*Wab Writes the local configuration profile a to remote user profile b and
resets the remote modem from that profile:
a= 0-3, local user profile number.
4, local active configuration.
5, local factory default settings.
b= 0-3, remote user profile number.
Note: The command *Rab only works when the modem is on-line, inde-
pendent of the type of connection involved.
Note: This command requires the supervisor password before execution.
Note: The command *Wab only works when the modem is on-line inde-
pendent of the type of connection involved.