Filter
Top Products
9–10
&X1 The terminal provides synchronous transmit clock signal. (External
clock from pin 24 of EIA-232D.)
&X2 The receiving carrier provides synchronous transmit clock signal.
(Remote or Slave clock to pin 15 of EIA-232D.)
&Y0 Destructive break, expedited. (Destructive break clears the buffer,
expedited break is sent immediately.)
+ &Y1 Non-destructive break, expedited. (Default)
&Y2 Non-destructive break, un-expedited.
&Zn=s Stores the dial string(s) to EEPROM at location n (0 ≤ n ≤ 49).
&Z? Displays all the phone numbers stored in EEPROM.
Extended AT* Command Set
+ *B0 Disables dial-backup. (Default)
*Bn Enables dial-backup and sets dial backup pointer at location n-1.
(See also S44b2)
+ *C0 10-bit character length. (Default)
*C1 11-bit character length.
*C2 9-bit character length.
*C3 8-bit character length.
*Dn Sets default dial pointer at phone directory location n. (See also
S35b4, S38b0, &Zn, &D1.)
+ *E0 If error control negotiation fails, the modem keeps the non-error
control connection. (Default)
*E1 If error control negotiation fails, disconnects the call (hang-up).
+ *F0 Denies remote configuration. (Default)
*F1 Accepts remote configuration (and Remote Digital Loopback must
be granted - AT&T4).
+ *G0 Disables security function. (Default)
*G1 Enables type 1 security, with password check.
*G2 Enables type 1 security, with password check and call back.
*G3 Enables type 2 security, with password check.
*G4 Enables type 2 security, with password check and call back.