Filter
Top Products
15–11
+FNS="
string
" Non-standard byte string parameter.
"string": string of hexadecimally coded octets.
+FPI="
string
" Local fax station ID string, for polling Rx.
+FPP=n Packet protocol control parameter:
n=0 Disables the DCE-DTE packet protocol.
n=1 Enables the DCE-DTE packet protocol. All multi-
character messages from the DCE are sent to the
DTE using a simple packet protocol data link.
+FPR=n Serial port rate control parameter:
n=0 Automatic DTE rate detection by the DCE.
n>0 Serial rate is fixed at the value multiplied by
2400bps. For example, when n=8, the DTE
rate is equal to 19200bps (8x2400).
+FPS=n Page transfer status: refer to the +FPTS Class 2
command on page 15-6 for parameter
descriptions.
+FRQ=pgl, cbl Receiving quality thresholds parameters:
pgl=
0-64
(HEX
value)
Specifies the percentage of good lines (e.g. with
negotiated number of pixels) required for a page
considered acceptable. The percentage of good
lines would be computed by the equation:
100 x (<lc> - <bl>) / <lc>
lc: total line count as reported in the +FPS:
response.
bl: bad line count as reported in the +FPS:
response.
If the resulting value is less than the value in
<pgl>, the page is unacceptable.
cbl=
0-FF
(HEX
value)
Specifies the maximum tolerable number of
consecutive bad lines. If this value is exceeded
for a given page, the DCE shall consider the
page unacceptable.
+FRY=n 0-255 ECM retry value: n=0-255, units of 4 retries.
+FSP=n Enable polling command:
n=0 Disables polling.
n=1 Enables polling.