Filter
Top Products
Chapter 8 Basic Setting
XGS-4526/4528F/4728F User’s Guide
108
Note: The uplink port connected to the Internet should be the root port. Otherwise,
with smart isolation enabled, the isolated ports cannot access the Internet.
8.5 Switch Setup Screen
Click Basic Setting and then Switch Setup in the navigation panel to display the
screen as shown. The VLAN setup screens change depending on whether you
choose 802.1Q or Port Based in the VLAN Type field in this screen. Refer to the
chapter on VLAN.
Figure 34 Basic Setting > Switch Setup
The following table describes the labels in this screen.
Table 12 Basic Setting > Switch Setup
LABEL DESCRIPTION
VLAN Type Choose 802.1Q or Port Based. The VLAN Setup screen changes
depending on whether you choose 802.1Q VLAN type or Port Based
VLAN type in this screen. See Chapter 9 on page 117 for more
information.
Bridge Control
Protocol
Transparency
Select Active to allow the Switch to handle bridging control protocols
(STP, for example). You also need to define how to treat a BPDU in the
Port Setup screen.