Filter
Top Products
Chapter 4 The Web Configurator
XGS-4526/4528F/4728F User’s Guide
52
VLAN Mapping This link takes you to screens where you can configure VLAN mapping
settings on the Switch.
Layer 2
Protocol
Tunneling
This link takes you to a screen where you can configure L2PT (Layer 2
Protocol Tunneling) settings on the Switch.
sFlow This link takes you to screens where you can configure sFlow settings on
the Switch.
PPPoE This link takes you to screens where you can configure how the Switch
gives a PPPoE termination server additional subscriber information that
the server can use to identify and authenticate a PPPoE client.
Errdisable This link takes you to a screen where you can configure CPU protection
and error disable recovery.
Private VLAN This link takes you to a screen where you can block traffic between ports
in a VLAN on the Switch.
IP Application
Static Route This link takes you to a screen where you can configure static routes. A
static route defines how the Switch should forward traffic by configuring
the TCP/IP parameters manually.
Policy Routing This link takes you to screens where you can configure policy routing
rules.
RIP This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
OSPF This link takes you to screens where you can view the OSPF status and
configure OSPF settings.
IGMP This link takes you to a screen where you can configure the IGMP
settings.
DVMRP This link takes you to a screen where you can configure the DVMRP
(Distance Vector Multicast Routing Protocol) settings.
DiffServ This link takes you to screens where you can enable DiffServ, configure
marking rules and set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP
settings.
VRRP This link takes you to screens where you can configure redundant virtual
router for your network.
ARP Learning This link takes you to a screen where you can configure ARP learning
mode on a per-port basis.
Load Sharing This link takes you to a screen where you can enable Equal-Cost
MultiPath (ECMP) routing and set the criteria the Switch uses to
determine the routing path for a packet.
Management
Maintenance This link takes you to screens where you can perform firmware and
configuration file maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login
password and configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and can
test port(s).
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION