Filter
Top Products
Chapter 13 Spanning Tree Protocol
XGS-4526/4528F/4728F User’s Guide
160
13.7 Multiple Rapid Spanning Tree Protocol
Status
Click Advanced Application > Spanning Tree Protocol in the navigation panel
to display the status screen as shown next. See Section 13.1 on page 147 for
more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 66 Advanced Application > Spanning Tree Protocol > Status: MRSTP
Priority Configure the priority for each port here.
Priority decides which port should be disabled when more than one port
forms a loop in the Switch. Ports with a higher priority numeric value
are disabled first. The allowed range is between 0 and 255 and the
default value is 128.
Path Cost Path cost is the cost of transmitting a frame on to a LAN through that
port. It is recommended that you assign this value according to the
speed of the bridge. The slower the media, the higher the cost - see
Table 26 on page 148 for more information.
Tree Select which STP tree configuration this port should participate in.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 31 Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL DESCRIPTION