Filter
Top Products
Chapter 9 VLAN
XGS-4526/4528F/4728F User’s Guide
124
9.5.4 Configure VLAN Port Settings
Use the VLAN Port Setting screen to configure the static VLAN (IEEE 802.1Q)
settings on a port. See Section 9.1 on page 117 for more information on static
VLAN. Click the VLAN Port Setting link in the VLAN Status screen.
Figure 42 Advanced Application > VLAN > VLAN Port Setting
Control Select Normal for the port to dynamically join this VLAN group using
GVRP. This is the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN
group.
Tagging Select TX Tagging if you want the port to tag all outgoing frames
transmitted with this VLAN Group ID.
Add Click Add to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to start configuring the screen again.
VID This field displays the ID number of the VLAN group. Click the number to
edit the VLAN settings.
Active This field indicates whether the VLAN settings are enabled (Yes) or
disabled (No).
Name This field displays the descriptive name for this VLAN group.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 18 Advanced Application > VLAN > Static VLAN (continued)
LABEL DESCRIPTION