Filter
Top Products
Chapter 18 Port Authentication
XGS-4526/4528F/4728F User’s Guide
195
Timeout Specify the amount of time before the Switch allows a client MAC
address that fails authentication to try and authenticate again. Maximum
time is 3000 seconds.
When a client fails MAC authentication, its MAC address is learned by the
MAC address table with a status of denied. The timeout period you
specify here is the time the MAC address entry stays in the MAC address
table until it is cleared. If you specify 0 for the timeout value, then this
entry will not be deleted from the MAC address table.
Note: If the Aging Time in the Switch Setup screen is set to a
lower value, then it supersedes this setting. See Section 8.5
on page 108.
Port This field displays a port number.
* Use this row to make the setting the same for all ports. Use this row first
and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this checkbox to permit MAC authentication on this port. You must
first allow MAC authentication on the Switch before configuring it on
each port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 46 Advanced Application > Port Authentication > MAC Authentication
LABEL DESCRIPTION