ZyXEL Communications 4528F Switch User Manual


 
Chapter 35 Policy Routing
XGS-4526/4528F/4728F User’s Guide
326
The following table describes the labels in this screen.
Table 110 IP Application > Policy Routing > Rule Configuration
LABEL DESCRIPTION
Profile Name This field displays the policy routing profile(s) you configure in the IP
Application > Policy Routing screen.
Select a profile for which you want to configure a policy routing rule.
Sequence Enter the rule number from 1 to 64. The ordering of your rules is
important as rules are applied in turn.
You can not specify a number already in use by another rule.
Statement Select Permit to forward traffic that matches this rule to the gateway
specified in the rule.
Select Deny to disable the rule action and forward traffic that matches
this rule according to the routing table on the Switch.
Classifier This field displays the available active classifiers you configure in the
Classifier screen (see Chapter 20 on page 201), which are not used by
any policy rule or policy routing rule.
Select a classifier to which this policy routing rule applies.
Action Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Switch that will forward the packet to the destination.
Add Click Add to insert the entry in the summary table below and save your
changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to set the above fields back to the factory defaults.
Active This field displays whether the policy route profile is enabled or not.
Profile Name This field displays the name of the policy route profile with which the rule
is associated.
Seq This field displays the rule index number that you configure in the
Sequence field. Click an index number to change the rule’s Statement.
State This field displays permit when the rule action is activated and deny
when is it deactivated.
Classifier This field displays the name of the classifier to which this policy applies.
Rule Delete Select the policy routing rule(s) that you want to remove.
Delete Click Delete to remove the selected entry(ies) from the summary table.
Cancel Click Cancel to clear the Rule Delete check boxes.