Filter
Top Products
AES-100 User’s Guide
ADSL Configuration 4-3
4.4.4 Enable Port Command
Syntax:
enable port <port number>
where
<port number> = port number, from 1 to 8
The enable port command forcibly enables the specified ADSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can occur.
An enabled but disconnected ADSL port generates more heat than an operating port. To minimize heat
generation and to enhance reliability, remember to disable a port when it is not in use.
4.4.5 Enable Ports Command
Syntax:
enable ports
The enable ports command forcibly enables all ADSL ports.
The factory default of all ports is disabled. A port must be enabled before data transmission can occur.
An enabled but disconnected ADSL port generates more heat than an operating port. To minimize heat
generation and to enhance reliability, remember to disable a port when it is not in use.
4.4.6 Linedata Command
Syntax:
linedata <port number>
where
<port number> = port number, from 1 to 8
The linedata command shows the line bit allocation of an ADSL port.
An example is shown next.
192.168.1.1 adsl> linedata 7
DS carrier load: number of bits per symbol(tone):
tone 0- 31: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
tone 32- 63: 0 0 0 22 22 33 33 33 33 33 33 44 33 44 44 44
tone 64- 95: 4 44 44 43 43 33 34 44 33 44 44 34 44 43 33 44
tone 96-127: 44 43 34 44 44 33 43 44 44 34 44 44 33 44 44 44