Filter
Top Products
AES-100 User’s Guide
10 Mbps Ethernet Port Configuration 5-1
Chapter 5
10 Mbps Ethernet Port Configuration
The Ethernet subsystem allows you to configure and monitor the 10 Mbps Ethernet port.
5.1 10 Mbps Ethernet
The AES-100 supports 10 Mbps Ethernet. In a 10 Mbps Ethernet, the duplex mode can be half duplex or full
duplex.
The Ethernet port uses the pre-configured duplex mode setting when making a connection, thus requiring you to
check the setting of the peer Ethernet port in order to connect.
5.2 Default Settings
The factory default setting for the Ethernet port of the AES-100 is
- Half duplex
5.3 Ethernet Commands
5.3.1 Set Duplex Command
Syntax:
set duplex <mode>
where
<mode> = full or half
The set duplex command sets the duplex mode used.
5.3.2 Status Command
Syntax:
status
The status command shows the current status of the Ethernet port.