Filter
Top Products
AES-100 User’s Guide
Remote Management 8-3
access <read | write> <community> [<IP addr>]
where
<read | write> =
Specifies read-only/read-write permission.
<community> =
Password needed to access the SNMP agent on the AES-100.
[<IP addr>] =
Optional IP address of the allowed SNMP manager.
This command allows read-only or read-write access. If the IP address is specified, access is allowed for the
manager station with that address only.
8.3.2 SNMP Access Delete command
Syntax:
access delete <community> [<IP addr>]
This command revokes SNMP access by the specified community (password). If the IP address is specified,
access is denied for that manager station only.
8.3.3 SNMP Access Flush Command
Syntax:
access flush
This command revokes access by any and all manager stations.
8.3.4 SNMP Access List Command
Syntax:
access list
This command shows the allowed access.
8.4 SNMP Trap Configuration
The AES-100 uses the SNMP trapping facility to proactively report unusual events to one or more trap servers.
To configure the trap parameters, use the trap commands in the SNMP subsystem. After configuring the SNMP
trap parameters, save the configuration to the nonvolatile memory with the config save command.
8.4.1 Supported Traps
AES-100 supports the following traps