Filter
Top Products
136 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
■ rip metricin
■ rip metricout
■ rip output
■ rip split-horizon
■ rip version
■ rip work
■ summary
■ timers
IP Routing Policy Commands
■ apply cost
■ display ip ip-prefix
■ display route-policy
■ if-match { acl | ip-prefix }
■ if-match cost
■ if-match interface
■ if-match ip next-hop
■ ip ip-prefix
■ route-policy
Routing Table Display
Commands
This section describes the commands you can use to display routing table
information.
When the Switch 4500 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router, or
to the Switch 4500 running a routing protocol.
display ip routing-table Syntax
display ip routing-table
View
All views
Parameter
None
Description
Use the display ip routing-table command to view a summary of routing
table information
Each line in the table represents one route. The displayed information includes
destination address/mask length, protocol, preference, cost, next hop and output
interface.