9
USING STACK COMMANDS
This chapter describes how to use the following commands:
Stack Configuration Commands
■ change self-unit
■ change unit-id
■ display ftm
■ display xrn-fabric
■ fabric save-unit-id
■ fabric-port enable
■ ftm stacking-vlan
■ xrn-fabric authentication-mode
■ set unit name
■ sysname
Stack Commands This section describes how to use the stack configuration commands on your
Switch 4500.
change self-unit Syntax
change self-unit to { <1-8> | auto-numbering }
View
System View
Parameter
self-unit: Unit ID of the device.
auto-numbering: Changes the unit ID automatically.
Description
Use the change self-unit command to change the unit ID of the current Switch.
By default, the unit ID of a Switch is set to 1. A unit ID can be set to a value in the
range from 1 to the maximum number of devices supported in the stack.
Example
To change the unit ID of the current Switch to 3, enter the following:
<4500>system-view
[4500]change self-unit to 3