Filter
Top Products
RIP Configuration Commands 159
To set MD5 authentication on Vlan-interface 1 with the key string set to “aaa”
and the packet type set to
usual, enter the following:
[4500]interface Vlan-interface 1
[4500-Vlan-interface1]rip version 2
[4500-Vlan-interface1]rip authentication-mode md5 usual aaa
rip input Syntax
rip input
undo rip input
View
Interface View
Parameter
None
Description
Use the rip input command to allow an interface to receive RIP packets. By
default, all interfaces except loopback interfaces are able to receive RIP packets.
Use the undo rip input command to block an interface from receiving RIP
packets.
This command is used in conjunction with two other two commands: rip output
and
rip work. The rip input and rip output commands control, respectively,
the receipt and the transmission of RIP packets on an interface. The
rip work
command allows both receipt and transmission of RIP packets.
Related commands: rip output, rip work.
Example
To set the interface Vlan-interface 1 not to receive RIP packets, enter the
following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Vlan-interface 1
[4500-Vlan-interface1]undo rip input
rip metricin Syntax
rip metricin value
undo rip metricin
View
Interface View
Parameter
value Enter an additional route metric to be added when receiving a packet,
ranging from 0 to 16. By default, the value is 0.