Filter
Top Products
20 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
Description
Use the command-privilege level command to configure the priority level
assigned to any command within a selected view.
The command levels are, from lowest to highest:
■ 0 – Visit
■ 1 – Monitoring
■ 2 – System
■ 3 – Management
When the user logs into the Switch, the commands used depends on the user level
settings and the command level settings on the user interface. The two types of
settings may differ as follows:
■ If AAA/RADIUS authentication is used, the commands the user can access are
determined by the user level settings. For example, if a user is set to level 3 and
the command level on the VTY 0 user interface is level 1, the user can only user
the commands of level 3 or lower when logging into the Switch from the VTY
interface.
■ If RSA public key authentication is used, the commands the user can access are
determined by the command level settings on the user interface.
By default:
■ ping, tracert, and telnet are at level 0
■ display and debugging are at level 1
■ all configuration commands are at system level 2
■ FTP, XMODEM, TFTP and commands for file system operations are at level 3
Use the undo command-privilege view command to restore the default priority
to a command.
Example
To configure the precedence of the command ‘interface’ as 0, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]command-privilege level 0 view system interface
databits Syntax
databits { 7 | 8 }
undo databits
View
User interface view
Parameter
7 – Sets the data bits to 7.