Filter
Top Products
88 CHAPTER 4: USING POWER OVER ETHERNET (POE) COMMANDS
PoE Configuration
Commands
This section describes the commands you can use to configure and manage the
PoE on your Switch 4500 PWR.
display poe interface Syntax
display poe interface [ interface-name | interface-type
interface-num ]
View
Any view
Parameter
interface-name | interface-type interface-num: Port on the Switch.
Description
Use the display poe interface command to view the PoE status of a specific
port or all ports on the Switch.
Example
Display the PoE status of the Ethernet port Ethernet1/0/10.
[4500]display poe interface ethernet1/0/10
Port power enabled :enable
Port power ON/OFF :on
Port power status :Standard PD
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :15400 mW
Port current power :460 mW
Port peak power :552 mW
Port average power :547 mW
Port current :10 mA
Port voltage :51 V
Display the PoE status of all ports.
[4500]display poe interface
PORT INDEX POWER ENABLE MODE PRIORITY STATUS
Ethernet1/0/1 off enable signal low Detection
Ethernet1/0/2 off enable signal low Detection
Ethernet1/0/3 off enable signal low Detection
Ethernet1/0/4 off enable signal low Detection
Ethernet1/0/5 off enable signal low Detection
Ethernet1/0/6 off enable signal low Detection
Ethernet1/0/7 off enable signal low Detection
Ethernet1/0/8 off enable signal low Detection
Ethernet1/0/9 off enable signal low Detection
Ethernet1/0/10 off enable signal low Detection
Ethernet1/0/11 off enable signal low Detection
Ethernet1/0/12 off enable signal low Detection
Ethernet1/0/13 off enable signal low Detection
Ethernet1/0/14 off enable signal low Detection