Filter
Top Products
Ethernet Port Link Aggregation Commands 67
AL AL Partner ID Select Standby Share Master
ID Type Ports Ports Type Port
-------------------------------------------------------------------
1 D 0x8000,00e0-fcff-ff01 1 0 NonS Ethernet4/0/1
10 M none 1 0 NonS Ethernet4/0/2
20 S 0x8000,00e0-fcff-ff01 1 0 NonS Ethernet4/0/3
display link-aggregation
verbose
Syntax
display link-aggregation verbose [ agg_id ]
View
Any view
Parameter
agg_id: Aggregation group ID, which must be a valid existing ID, in the range of
1 to 416.
Description
Use the display link-aggregation verbose command to view detailed
information of a link aggregation, including aggregation ID, the type of
aggregation, load-sharing type, detailed local information (member ports, port
status, port priority, LACP state flag and operation key), and detailed remote
information (indexes of remote ports, port priority, LACP state flag, operation key
and system ID.)
Note that unlike a dynamic aggregation, a manual aggregation has no protocol to
get the remote peer information of the partner. Therefore, every item for the
remote peer is 0. This does not indicate the actual state of the remote peer.
Example
To display detailed information of aggregation group 1, enter the following:
<4500>display link-aggregation verbose 1
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Aggregation ID: 1, AggregationType: Manual, Loadsharing Type: NonS
Aggregation Description:
System ID: 0x8000, 000f-cbb7-2e00
Port Status: S -- Selected, U -- Unselected
Local:
Port Status Priority Flag Oper-Key
--------------------------------------------------------------------
Ethernet1/0/2 U 32768 0x00 1
Ethernet1/0/3 U 32768 0x00 1
Ethernet1/0/4 S 32768 0x00 1
Remote:
Actor Partner Priority Flag Oper-Key SystemID
--------------------------------------------------------------------
Ethernet1/0/2 0 0 0x00 0 0x0,0000-0000-0000
Ethernet1/0/3 0 0 0x00 0 0x0,0000-0000-0000
Ethernet1/0/4 0 0 0x00 0 0x0,0000-0000-0000
<4500>