Filter
Top Products
24 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
flow-control Syntax
flow-control { hardware | none | software }
undo flow-control
View
User interface view
Parameter
hardware: Enter to set hardware flow control.
none: Enter to set no flow control.
software: Enter to set software flow control.
Description
Use the flow-control command to configure the flow control mode on the AUX
(Console) port to hardware, software or none. Use the
undo flow-control
command to restore the default flow control mode (no flow control).
This command can only be performed in the AUX user interface view.
Example
To configure software flow control on the AUX (Console) port, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]user-interface aux 0
[4500-ui-aux0]flow-control software
free user-interface Syntax
free user-interface { type | number }
View
User view
Parameter
type: Enter the type and type number of the user interface to be reset.
number: Enter the index number of the user interface to be reset.
Description
Use this command to reset a specified user interface to its default settings. The
user interface will be disconnected after the reset.
Use free user-interface type to reset the interface with the specified type
and type number to its default settings. Use
free user-interface number to
reset the interface with the specified index number to its default settings.
You cannot use this command on the current user interface.