Filter
Top Products
B-32 APPENDIX B: CLI COMMAND DESCRIPTION
■
transmit_authentication_name [name]
Specifies system contact information, which is displayed using show system. The
user name is the remote account name. Location, name and contact names are
limited to 64 characters.
from managers on the network must match the list, which you can see using list
snmp communities.
set syslog <IP_address>
loglevel [level
]
Sets the error reporting level for syslog entries that will be sent to the specified IP
address. You must have previously defined this syslog IP address using add syslog.
There are five levels of logging:
■ CRITICAL - a serious system error, which may effect system integrity
■ UNUSUAL - an abnormal event, which the system should recover from
■ COMMON - a regularly occurring event that is not frequent
■ VERBOSE - a regular periodic event, e.g. a routing update message
■ DEBUG - for debugging only
set time <time> Sets the system time, and leaves the date unchanged. Use show date to see what
the current settings are. The format is: hh:mm:ss. The seconds field is optional.
set user <user_name> ■ message [“message”]
■ password [password]
■ session_timeout [seconds]
■ tcp_port [tcp_port]
■ terminal_type
Modifies user parameters.
set vc <vc_name> ■ address_selection [negotiate | assign | specified]
Parameters Description
name A name identifying the user to the system.
location The location of the user.
contact The information contact for the user.
transmit_
authentication_name
Deprecated
Parameters Description
<user_name> Name of user, previously defined using add user. Limit of 32 characters.
message Message presented to a dial-in user.
password User’s password, up to 15 ASCII characters. Value is required.
session_timeout Interval before timing out a session.
tcp_port TCP Port number for the Telnet session.
Terminal_type The type of terminal. This is an alphanumeric string, of up to 64 characters.