Filter
Top Products
5-4 CHAPTER 5: QUICK VC SETUP
IPX Routing (Network
Service PPP)
The IPX configuration for VC “name” is now complete.
IPX Routing (Network
Service RFC 1483)
The IPX configuration for VC “name” is now complete.
Bridging
The OfficeConnect Remote 812 can be configured to send and receive the routed
(IP and IPX) packets using bridged encapsulation (i.e., Bridged-1483 or BRCP or
PP), where the MAC-header is included in each packet. The routing rules for [IP
and IPX] will be applied to each packet.
Review
Sample Identification
Information
This section contains a sample of possible settings.
Encapsulation type: PPP
ATM information:
VPI/VCI: 0/33
Question Default Your System
Is IPX traffic going to be routed over VC “name”? [no]
Is the IPX WAN interface (S)pecified or (L)earned? [L]
Is the IPX WAN interface (U)nnumbered or (N)umbered? [N]
Enter the IPX network number for the WAN? [ ]
Do you want IPX routing (RIP) to run over the WAN? [yes]
Question Default Your System
Is IPX traffic going to be routed over VC “name”? [no]
Is the IPX WAN interface (U)nnumbered or (N)umbered? [N]
Enter the IPX network number for the WAN? [ ]
Do you want IPX Routing (RIP) to run over the WAN? [yes]
Question Default Your System
Do you want to Bridge any traffic over VC “name”? [no]
Question Default Your System
Do you want to enable MAC-encapsulated routing? [no]
Question Default Your System
Would you like to review your answers before executing
them ?
[yes]