Filter
Top Products
5-2 CHAPTER 5: QUICK VC SETUP
The Category of Service and cell rate parameters only affect data transmitted from
the OfficeConnect Remote 812 to the remote site (upstream direction). The
default value of UBR with a Peak Cell Rate of 0 will attempt to use all available
upstream bandwidth when transmitting to the remote site.
The ATM Configuration for VC “name” is now complete.
Network Service The OfficeConnect Remote 812 suppports either PPP, PPPoE, or RFC 1483
encapsulation.
PPP Parameters (Only applicable if PPP or PPPoE is chosen as the network service.)
You must configure a name and password that will be used during the PPP
authentication process.
The authentication name for VC “name” is now complete.
IP Configuration
(Network Service PPP)
(Only applicable if PPP is chosen as the network service.)
Network Address Translation (NAT) allows a single WAN-side IP address to be
‘shared’ by multiple LAN-side devices.
Local and remote IP adresses can be configured in two different ways:
■ Specified: the IP adress is always a specific address.
■ Learned: the IP address is learned when the PPP connection is established.
One active VC profile can have its remote router installed as the default router in
the OfficeConnect Remote 812’s IP route table.
You can use Routing Information Protocol (RIP) to exchange routing information
with other routers on the network.
Enter the Peak Cell Rate: [0]
Question Default Your System
Select the encapsulation type [ppp]
Question Default Your System
What is the authentication name ? [name]
What is the authentication password? [ ]
Question Default Your System
Is IP traffic going to be routed over VC “name”? [yes]
Do you want to enable IP Network Address Translation (NAT)? [yes]
Is the remote IP address (S)pecified or (L)earned? [L]
Enter the IP address of the router across the WAN: (specified
only)
[ ]
Enter the IP mask for the router across the WAN: (specified
only)
[C]