Filter
Top Products
B-14 APPENDIX B: CLI COMMAND DESCRIPTION
disable security_option
remote_user
administration
Disables CLI access to remote TELNET users. All CLI configuration must be done
from the console port. You can use enable security_option remote_user
administration to re-enable remote CLI access.
disable snmp
authentication traps
Instructs SNMP to stop recording trap information for user (either local or remote)
authentication.
disable telnet escape Disables the TELNET escape character for all TELNET clients. When disabled,
TELNET clients who press the escape character during their session will not get a
local TELNET command line.
disable user
<user_name>
Disables the specified user from being used. It also causes all active sessions
established using that particular user to terminate, and does not allow any new
sessions to occur using that user name. Disabling a user is useful when prohibiting
a user’s access temporarily.
disable vc
<user_name>
Disables the specified virtual channel from being used. It also causes any active
session established using that particular VC to terminate, and does not allow any
new sessions to occur using that VC. Disabling a VC is useful when prohibiting a
VC’s access temporarily.
DO
do
<command_inputfile>
output [outputfile]
Runs a script file that is stored in FLASH memory, which contains a series of CLI
commands.
ENABLE
enable access Enables the Access List feature. When enables, onlly Remote Hosts in the access
list are permitted access to the Router’s management services.
enable bridge network
<network_name>
Enables bridging over the specified network. You must have previously run add
bridge network to add bridging over this network. bridge networking is enabled
by default, so you will only need to use this command if you have previously
disabled this bridge. Note that bridging will not occur for a protocol, if routing is
enabled for that protocol.
enable bridge
spanning_tree
Enables the spanning tree algorithm for the bridge connection. The spanning tree
algorithm is required if there is more than one bridge between the same two LAN
segments. You can use list bridge forwarding to see which bridges are defined,
and show bridge network <network_name> settings to see which options are
enabled on a particular bridge network.
enable command
password <password>
Enables the console password feature. When enabled, the user must login with
the specified password before using the console port. This password is not the
same password specified for Remote Login access. Once enabled, the unit must be
sent back to the factory if the password is forgotten.