Filter
Top Products
B-34 APPENDIX B: CLI COMMAND DESCRIPTION
default_route_
option
When enabled, a default route is automatically created (by negotiation)
with the remote router’s IP address.
Destination_
address
For an SVC, this is the destination E.164 address to which a connection
will be established.
End_time This field is the end time for the virtual circuit. The expected format is
HH:MM:SS. The Seconds field is optional.
Header_
compression
This determines whether you will have no compression on cell headers, or
if you will use TCP/IP compression on the cell headers transmitted across
this vc.
idle_timeout Interval to wait before timing out an inactive connection. Default: 300
seconds.
input_filter Designation of the filter file in FLASH memory to be applied to the input
data stream.
ip Sets interface to enable/disable protocol. Default is enable.
ip_routing Sets routing type (RIP packets) accepted on this connection. Options:
LISTEN - detects packets destined for system’s nets
SEND - routes packets destined for the remote network
BOTH - both of the above
NONE - ignores all routing packets
ip_source_
validation
When enabled, any packet who’s source IP address falls within the LANs
IP network will be dropped.
ipx This controls whether to enable or disable IPX for the virtual circuit. The
choices are [ENABLE, DISABLE].
ipx_address This sets the IPX address for the virtual circuit.
ipx_routing This sets the routing type (RIP packets) accepted on this connection.
Options are:
ALL - listens, sends, and responds RIP packets.
LISTEN - detects packets destined for the system’s network.
NONE - ignores all routing packets.
RESPOND - responds by sending out packets
SEND - routes packets destined for the remote network.
ipx_wan This determines if IPX is enabled or disabled for the WAN. Options are
[ENABLED, DISABLED].
local_IP_address IP address of the VC making an IP connection over the WAN interface.
There are two special values which may be assigned to the
local_IP_address:
The local_IP_address should be learned via PPP negotiation
(255.255.255.255).
The interface is Unnumbered (0.0.0.0).
mac_routing Determines if MAC-Encapsulated Routing is enabled.
management_ip_
address
Secondary IP address on the VC for Management purposes only. If the
Management IP address is configured, the ‘local_IP_address’ must be
configured as numbered.
Address is configured with the following format:
xx.xx.xx.xx/nn -- where nn is the number of bits in the netmask or
netmask class (i.e., A, B, or C).
MTU Maximum Transfer Unit - largest data packet size allowed.
NAT_option Enable / disable Network Address Translation.