Filter
Top Products
B-12 APPENDIX B: CLI COMMAND DESCRIPTION
delete network service
<service_name>
Deletes the specified network service from the list of available services. You must
use disable network service before deleting the service. You can see which services
are available and active using list available services and list services.
delete snmp
community <name>
Deletes an SNMP community that was previously added with the add snmp
community command. You can use list snmp communities to see the current
entries.
delete snmp
trap_community
<name>
Deletes an SNMP trap community name from the list of names and IP addresses
that are allowed to receive SNMP trap commands. You can use list snmp
communities to see the current entries.
delete syslog
<ip_name_or_address>
Deletes the specified IP host name or IP address from the list of addresses which
are authorized to receive syslog information. Use list syslog to see the currently
allowed addresses.
delete tftp client
<ip_name_or_address>
Deletes the specified IP host name or IP address from the list of addresses which
are authorized to TFTP. Use list tftp clients to see the currently allowed addresses.
delete user <name> Deletes a user you previously added to the local user table. Use list users to see the
currently defined user, and show user to see the attributes you assigned to that
user using the add user or set user command.
delete vc <name> Deletes a virtual channel profile. Use list vc to see the currently defined VCs, and
show vc to see the attributes of a specific VC. A VC must be disabled before it can
be deleted.
DIAL
dial <vc_name> Generates an outgoing connection to the location specified by the vc name. You
can use list vcs to list the defined vc profiles, and their current status.
DISABLE
disable access Disables the Access List feature. When disabled, all hosts are permitted to access
the Router’s management services.
disable bridge network
<name>
Disables the bridge network you previously defined using the add bridge network
command. You can see which bridge networks are currently running using list
bridge forwarding.
disable bridge
spanning_tree
Disables use of the spanning tree algorithm on bridge networks. The spanning
tree algorithm is required if there is more than one bridge between the same two
LAN segments. You can use list bridge forwarding to see which bridges are
defined, and show bridge network settings to see which options are enabled on a
particular bridge network.