Filter
Top Products
122 APPENDIX A: TROUBLESHOOTING
error, a message is sent to the console and you are returned to the boot
monitor.
Errors include:
■ The file does not exist.
■ The file has the wrong format.
■ The file has a bad checksum.
Configure Flash Load
Syntax CL
Description The CL command allows you to configure the following settings to
identify a TFTP server for downloading or dumping memory:
1. Client
2. Server
3. Gateway
4. Subnet Mask
5. Boot Filename
6. Port Selection
7. Baud Rate
8. Duplex Mode
Clear EEPROM
Syntax CP
Description The CP command erases the EEPROM except for the MAC address. You
should only do this if advised by 3Com technical support.
Display Files
Syntax DF [<subdir>]
Description The DF command displays information about files on a file system or in
a specified directory. It also displays the available free space in the file
system.
Dump
Syntax DU
Description The DU command performs a memory dump to a TFTP server specified
in the CL command. See “Performing a Memory Dump” on page 145
to configure a memory dump in the software and to set up the TFTP
server.