Filter
Top Products
76 CHAPTER 6: BASIC CONFIGURATION OF PORTS AND PATHS
before you connect it to the SuperStack II bridge/router. See the
documentation that came with your TA for more information.
To configure the serial port with a DCE, follow these steps:
1 The default baud rate for the serial port is 64 Kbps. If you need to change
the baud rate, use:
SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)
2 The default device type is Modem. Specify the external device type
attached to the Flex-WAN cable using:
SETDefault !<path> -PATH ExDevType = [Modem | Bri | Sw56]
3 If you have changed any of the default settings, re-enable the path to
make sure all settings on the path take effect using:
SETDefault !<path> -PATH CONTrol = Enabled
Configuring Serial
Ports with DTEs
This section describes how to configure the serial ports when connecting
directly to IBM legacy equipment.
Before beginning this procedure, complete the following tasks:
■ Attach the Flex-WAN cable to the serial port and the DTE.
■ Log on to the system with Network Manager privilege.
The Flex-WAN serial port automatically detects the following settings:
■ Line type — leased
■ Clock — internal
■ Connector type — RS-232, V.35, X.21, or RS-449
To configure the serial port with a DTE, follow these steps:
1 The default baud rate for the serial port is 64 Kbps. If you need to change
the baud rate, use:
SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)
2 Set the owner of the serial port using:
SETDefault !<port> -PORT OWNer = BSC | ATUN | SHDLC | SDLC
See Using Enterprise OS Software for more information about IBM legacy
protocols.