Filter
Top Products
Where To Go From Here 99
Scenario 2: Fully
Meshed Topology
A fully meshed topology consists of bridge/routers that are connected
directly to every other bridge/router.
Obtain an X.25 address from the X.25 service provider for the serial port.
Where To Go From
Here
See Chapter 8 to configure bridging, IP routing, and IPX routing. To
configure other protocols, see Using Enterprise OS Software.
!6 (port)
NETBuilder/II
®
Modem
X.25
Modem
ModemModem
!5 (path)
311041501111
311041504444
311041502222
311041503333
Start here
Done
If you are attached to a public data network (PDN), specify the type:
SETDefault !6 -X25 PDNetworkType = TELENET | TYMNET | PSS | DDN | BFE |
NET2 | DATEX | TRANSPAC | LAPOSTE
SETDefault !<port> -X25 PDNetworkType = TELENET | TYMNET | PSS |
DDN | BFE | NET2 | DATEX | TRANSPAC | LAPOSTE
Enable X.25 on port 6:
SETDefault !6 -PORT OWNer = X.25
SETDefault !<port> -PORT OWNer = X.25Syntax:
Set the X.25 address for port 6:
SETDefault !6 -X25 X25Address = 311041501111
SETDefault !<port> -X25 X25Address = <0-99999999999999> (1-15 digits)
One serial port connects to
multiple destinations in a
fully meshed topology.
Syntax:
Syntax: