Filter
Top Products
3-2 3COM Security Switch 6200 Hardware and Software Users Guide
Interface Connections and First Time Start-Up
To connect to the serial connector use the DB9 serial connector located on the
front panel of the system.
NOTE: If you are connecting to the system Management Console using a
terminal or PC, the serial port on the terminal or PC must be configured for
9600 baud, 8 data bits, 1 stop bit, no parity, and no flow control.
Connecting a Terminal or PC to the System Front Serial Craft
Port
To connect a terminal or PC to the system front serial craft port:
1. Connect one end of a DB9-to-DB9 cable into the terminal or PC.
2. Connect the other end into the system serial craft port. Figure 3-1
shows the system connected to a laptop computer.
Figure 3-1 Connecting a Laptop Computer to the system Front Serial
Craft Port
3. Set to VT-100 terminal emulation mode.
Personal Computer
FIBER
10/100/1000
10/100
CONSOLE
(max) 9800,8,N,1
PACKET
LINK
1357
2468
9111315
10 12 14 16
FIBER
PACKET
LINK
17
18
PWR
MGMT1
MGMT2
SYS
HDD