3Com 6200 Switch User Manual


 
3-4 3COM Security Switch 6200 Hardware and Software Users Guide
Interface Connections and First Time Start-Up
2. Attach the male end of the power cable into an AC power source. The
system is powered up when power is applied to the power supplies.
NOTE: If the system is powered up with one power supply or if one of the
power supplies experiences a loss of power, an audible alarm sounds. To
silence this sound, press the red button located on the left side of the primary
power supply.
Startup and
Normal
Operation
LED Displays
During power up and normal operation, you can observe start-up activity
by checking LED activity on the system front panel.
Table 3-1 describes the various front panel LEDs and their function.
Table 3-1 Front Panel LED Descriptions
1. The PWR LED sleep indication is maintained on standby by the system. If the
system is powered down without going through BIOS, the LED state in effect at
the time of power off, is restored when the system is powered on until cleared by
the BIOS. If the system is not powered down normally, the PWR LED may
blink even though the SYS LED may be off due to a failure or configuration
change that prevents the BIOS from running.
2. The Amber status takes precedence over the Green status. When the Amber
LED is on or flashing, the Green LED is off.
3. This LED is also off when the system is powered off or in a sleep state.
LED Color/Label State Description
10/100 Fast Ethernet Green On Ethernet connectivity present.
Yellow Flashing Traffic is present.
10/100/100 Fast
Ethernet/Gigabit
Ethernet
Fiber/Green On Fiber connectivity present.
Activity/Green Flashing Traffic is present.
Link/Green On Ethernet connectivity present.
Power/Sleep(PWR) Green On Power on.
Flashing
1
In sleep state.
Off Off Power is off.
MGMT1/MGMT2 Green Random Flash NIC activity present.
System Status (SYS) Green On Running with normal operation.
Flashing
2
Degraded.
Amber On Critical or non-recoverable condition.
Flashing
2
Non-critical condition.
Off Off Post/system stop.
Disk Activity (HDD) Green Random Flash Disk activity present.
Off Off
3
No hard disk activity detected.