Filter
Top Products
3
CONFIGURING THE V7122 MEDIA
GATEWAYS
The V7122 gateway is supplied with application software already resident
in flash memory (with factory default 3Com parameters).
Assigning the V7122 IP Address below describes how to assign IP
addresses to the V7122. Configuring the V7122 Basic Control Protocol
Parameters describes how to set up the V7122 with basic parameters
using a standard Web browser (such as Microsoft Internet Explorer).
Assigning the
V7122 IP Address
The V7122 is composed of one or two identical media gateway modules.
These media gateways are fully independent, each gateway having its
own MAC and IP addresses.
To assign an IP address to each of the V7122 modules use one of the
following methods:
HTTP using a Web browser (see Assigning an IP Address Using HTTP).
The embedded Command Line Interface (CLI) accessed using Telnet (see
Assigning an IP Address Using the CLI).
Table 5 lists the default IP addresses of the V7122. You can use the Reset
button at any time to restore the V7122 networking parameters to their
factory default values (see
Restoring Networking Parameters to their
Initial State).
Table 5 V7122 Default Networking Parameters
V7122 Version Default Value
Single module (up to 8 trunks 10.1.10.10
Double module (up to 16 trunks) 10.1.10.10 (Trunks 1-8)
and
10.1.10.11 (Trunks 9-16)