Filter
Top Products
2-10 EXTENSA 700/710 Service Guide
•
The buzzer beeps
•
The Standby indicator lights
Note: Unstored data is lost when you turn off the computer power in
Standby mode or when the battery is drained.
To leave Standby mode and return to normal mode:
•
Press any key
•
Move the active pointing device (internal or external, PS/2 or serial)
•
Have the Resume Timer set and let it be matched
•
Open the display cover
•
Experience an incoming PC card modem event
Hibernation Mode
In Hibernation mode, all power shuts off (the computer does not consume
any power). The computer saves all system information onto the hard disk
before it enters Hibernation mode. Once you turn on the power, the computer
restores this information and resumes where you left off upon leaving
Hibernation mode.
There are two necessary conditions for the computer to enter Hibernation
mode:
•
The Hibernation file created by PhDISK must be present and valid. See
“PhDISK” on page 73.
•
Heuristic Power Management must be set to [ENABLED].
In this situation, there are four ways to enter Hibernation mode:
•
Pressing the Hibernation hot key
Fn-F4
•
If the waiting time determined by the computer’s HPM unit elapses
without any system activity
•
If a battery low condition occurs and the Battery Low Suspend
parameter in Setup is set to [ENABLED].
•
Invoked by the operating system power saving modes
Note: If the computer beeps but does not enter Hibernation mode after
pressing the Hibernation hot key, it means the operating system will
not allow the computer to enter the power-saving mode.
700SG-2.fm Page 10 Monday, June 8, 1998 1:26 PM