Filter
Top Products
2-5
Installing Your Adapter
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: 511472-00, Rev. A Page: 2-5
Print Spec Number: 496708-00
Current Date: 5/5/97 ECN Date: 5/97
Testing the PCI Configuration
Use
EMDIAG
to make sure the PCI adapter is configured properly.
For more information about
EMDIAG
, see Chapter 5, Using EMDIAG
to Troubleshoot Problems.
1
Type
A:\EMDIAG
and press Enter to start the Adaptec setup
program.
2
At the Main Menu, select Configuration Status.
3
The Configuration Status screen reports the resources in use by
the adapter.If the adapter has encountered a resource conflict
with another adapter, or is not yet fully configured,
EMDIAG
displays an error message.
Try repeating the installation and configuration procedures
again. If you still have difficulties, refer to Chapter 5, Using
EMDIAG to Troubleshoot Problems.
Testing the Quartet Configuration
If you are planning to use your quartet with Windows NT you must
first determine if your system's BIOS supports the PCI-to-PCI
bridge chip.
1
At
EMDIAG
's Main Menu, select PCI Device Information.
A screen similar to the following appears: