Filter
Top Products
4-4
PCI Ethernet and Fast Ethernet Adapters
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: 511472-00, Rev. A Page: 4-4
Print Spec Number: 496708-00
Current Date: 5/5/97 ECN Date: 5/97
EMPCI driver from the autoexec.ncf as well as the sys:etc\failover.ncf, if
this file exists.
1
At the console prompt type load inetcfg and press Enter.
2
Click Yes to transfer all commands from autoexec.ncf.
3
From the main menu, select Boards and press Enter. A list of
network adapters appears.
4
Press Ins to add a new driver. A list of available LAN drivers
appears.
5
Press Ins again and install the driver from the Netware driver
diskette. Specify the correct path to the new empci.lan (for
example, a:\nwserver\empci.lan).
6
Select the new empci from the updated list.
7
Type in a name for the newly added adapter.
8
Specify the index number in the next field (1 is the default for
the first board; set the next board at 2, and so forth).
9
Specify Half or Full Duplex mode.
10
Press Esc and save the configuration.
11
From the INETCFG main menu, select PROTOCOLS. Select
the appropriate protocols for your network.
12
Press Esc to exit, saving your protocol configuration.
13
From the INETCFG main menu, select BINDINGS. Highlight
the protocol to bind and press Ins. Repeat this step until all
bindings are complete. Repeat this step for any additional
adapters in the system.
14
Press Esc and save your configuration as you exit. Press Esc
again to exit the INETCFG utility.
15
At the server console type down and then type restart system to
start the new configuration.