Filter
Top Products
4-14
PCI Ethernet and Fast Ethernet Adapters
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: 511472-00, Rev. A Page: 4-14
Print Spec Number: 496708-00
Current Date: 5/5/97 ECN Date: 5/97
Forces the connection to 100 Mb/s in Full Duplex mode.
■
THIN
Use this when connecting to the BNC port of a Combo
adapter. This is a 10 Mb/s Half Duplex only connection.
■
THICK
Used for an adapter that uses an AUI port.This is a 10-
Mb/s Half Duplex only connection.
Note:
Be sure to select the appropriate cable type for your
network.
Click Continue.
19
Repeat step 18 for each Adaptec adapter installed in your
system. Each adapter can be identified by its unique PCI
Bus/PCI Slot number.
20
If SNMP has not been set up on this computer you will receive
the following setup Message: Install the NT SNMP service
and use configure option to configure Server related MIBs.
Click OK.
Installing the Duralink Driver for Windows NT 4.0
1
Place at least two Adaptec PCI adapters (such as
ANA-6911A/TX) in the system.
Note:
To avoid conflicts on the network, do not attach cables
from both adapters to a common hub until after the drivers
have been configured for failover and the system has
rebooted.
2
Boot your system with Windows NT 4.0.
3
Double-click the My Computer icon.
4
Double-click the Control Panel icon.
5
Double-click the Network icon.