Filter
Top Products
4-3
Installing Network Drivers
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: 511472-00, Rev. A Page: 4-3
Print Spec Number: 496708-00
Current Date: 5/5/97 ECN Date: 5/97
NetWare
Note:
Consult \readme\nw_stnd.txt and readme\nw_dura.txt files for
the latest driver information and installation instructions.
Some procedures or information may have changed or may
not have been available at the time this user’s guide was
printed.
The Novell NetWare driver,
\nwserver\empci.lan
is used with both
NetWare 3.1x and NetWare 4.x servers, and also with both
NetWare 3 SFT III and NetWare 4 SFT III.
Note:
An Adaptec LAN adapter cannot be used as an MSL
adapter in an SFT-III environment.
Note:
These instructions apply to standard drivers only. If
your adapter shipped with Duralink software, see Installing
the Duralink Driver for NetWare 4.x on page 4-5 or
\readme\nw_dura.txt.
Installing and Configuring the Standard Driver for
NetWare 4.x
Note:
Netware 4.1 requires two patches to enable the ODI
3.3 support. Download the server patch 410pt7.exe and the
NLM patch landr9.exe from http://support.novell.com. ODI 3.3
patches are not required for Netware 4.11.
Using the INETCFG utility
INETCFG.NLM is the recommended utility to properly install and con-
figure the Netware driver.
Before installing the Netware driver, delete all previously installed
adapters.Remove all load and bind commands relating to the