Filter
Top Products
Determine What You Need
2 MM701G and MM702G User Manual
STEP 2—DETERMINE WHAT YOU NEED
In addition to what is shipped with the modem, you need the following hardware and software
to complete the installation and configuration.
STEP 3—ATTACH FEET TO THE MODEM
Attach oval rubber feet to the modem to prevent it from slipping on surfaces (a desktop, for
example) and from scratching those surfaces. Do the following:
1 Remove the paper from the adhesive back of the oval rubber feet.
2 Attach each of the four oval rubber adhesive-backed feet to a footprint recess on the bottom
of the modem.
Equipment: Requirement:
PC Hardware:
• Ethernet NIC Card (10 Mbps) installed in each PC and other network equipment
that will be connected to the LAN. Verify if the NIC in the device which directly
connects to the modem LAN port is half- or full-duplex. The modem LAN port
must be set to the same transmission direction(s) as the NIC.
• Optional—serial interface card installed in PC (used for access to the modem
console port).
Software:
• TCP/IP protocol stack installed (see the operating system documentation for
information).
• Terminal emulation program (such as HyperTerminal) installed for access to
the command line interface. through the console port (see the operating system
documentation for information).
• Web browser installed such as Internet Explorer
®
Version 4.0 (or higher).
• Operating System CD-ROM (Win98, Win98SE, Win2000, WinME, or WinXP).
Ethernet hub, switch,
or router
Optional—use either a hub, switch, or a router to connect multiple PCs or other
LAN equipment to the modem Ethernet 10Base-T port (LAN port).