Filter
Top Products
Set Up the LAN
104 MM701G and MM702G User Manual
SET UP THE LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of
10.0.0.1 for the Ethernet Port IP Address, and
255.255.255.0 for the subnet mask.
1 From the
System Management main menu (page 102), enter 2 to display the LAN Configuration
menu.
2 Configure the following parameters, 1 through 6, for the PPP session:
LAN Protocol
Enter 1 then select one of the following for DHCP protocol:
•
1—Spanning Tree where you select 1 to Disable spanning tree protocol or select 2
to
Enable spanning tree protocol for all bridging sessions.
•
2—DHCP Client mode where you select 1 to Disable DHCP client mode or select 2
to
Enable DHCP client mode for the modem.
If a DHCP server is not set up and active on your LAN, do not enable DHCP
client. DHCP Client mode is recommended for use only when bridging is used
as the LAN protocol.