Filter
Top Products
Chapter 4: Configuring the WAN
MM701G and MM702G User Manual 31
DHCP Client
Select to enable DHCP client where this session will automatically received an IP
address from the service provider via a DHCP server. If you select DHCP client, leave
the next two fields, IP address and Subnet Mask, blank. These fields will automatically
receive values.
IP Address
Enter the IP address provided by the service provider for this session. Or if DHCP
Client was selected, the IP address will automatically be assigned by a DHCP server
on the WAN side of the network. The default IP address is 0.0.0.0.
Subnet Mask
Enter the subnet mask provided by the service provider for this session or use the
default subnet mask for the session which is 255.0.0.0. Or if DHCP Client was
selected, the subnet mask will automatically be assigned by a DHCP server on the
WAN side of the network.
RIP Send
This session forwards RIP version 1 (Ver 1), RIP version 2 multicast (Ver2 (M-cast)),
RIP version 2 broadcast (
Ver2 (B-cast)), or all versions of RIP packets. Select the RIP
version or versions the modem will send on this session. The default is
Ver2 (B-cast).
RIP Accept
This session receives RIP version 1 (Ver 1) only, RIP version 2 (Ver 2) only, or both
versions of RIP packets. Select the RIP version or versions the modem will receive for
this session. The default is RIP
Ver 1 and Ver 2.
2 Click
Create to add the new RFC1483-Router session to your session list on the WAN
Configuration
page.