Filter
Top Products
Configuring the Switch
3-154
3
Use the Policy Map page to specify a policy map. Then use the Class Map page to
configure a policy map. And finally, use the set and police commands to specify the
match criteria, where the:
- set - classifies the service that an IP packet will receive.
- police - defines the maximum throughput, burst rate, drop rate, and the action
that results from a policy violation.
Configuring a Class Map
A class map is used for matching packets to a specified class.
Command Attributes
• Modify Name and Description — Configures the name and a brief description of
a class map. (Range: 1-32 characters for the name; 1-256 characters for the
description)
• Edit Rules — Opens the Match Class Settings page. Enter the criteria used to
classify traffic on this page.
Class Table
- Class Name — Name of the class map. (Range: 1-32 characters)
- Match Any — Only one match command is permitted per class map, so the
match-any field refers to the criteria specified by the lone match command.
- Specified Criteria — Displays the currently specified match criteria for this class
map.
- Remove — Deletes the selected criteria.
Criteria
- ACL List — Name of an access control list. Any type of ACL can be specified,
including standard or extended IP ACLs and MAC ACLs. (Range: 1-16
characters)
- IP DSCP — List of DSCP values. Up to 8 values can be specified, each
separated by a space. (Range: 0-63)
- IP Precedence — List of IP Precedence values. Up to 8 values can be specified,
each separated by a space. (Range: 0-7)
- VLAN — List of VLANs. Up to 30 VLANs can be specified, each separated by a
space. A range of VLANs can be entered using a hyphen. (Range:1-4094)
- Add Class — Select this to create a class map used for matching packets to the
specified class, and enter the Class Configuration page.
- Remove Class — Deletes a specified class.
Command Usage
• Currently you may only configure one rule per Class Map.
• When creating Class Maps do not use the character ‘&’ in the name.