Filter
Top Products
Mirror Port Commands
4-141
4
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target port.
port monitor
This command configures a mirror session. Use the no form to clear a mirror
session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Switch (unit 1).
- port - Port number.
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is for both
received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-183).
Native VLAN Indicates the default Port VLAN ID (page 4-184).
Priority for untagged traffic Indicates the default priority for untagged frames (page 4-197).
Gvrp status Shows if GARP VLAN Registration Protocol is enabled or disabled (page 4-194).
Allowed Vlan Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 4-185).
Forbidden Vlan Shows the VLANs this interface can not dynamically join via GVRP (page 4-186).
Table 4-44. Mirror Port Commands
Command Function Mode Page
port monitor Configures a mirror session IC 4-141
show port monitor Shows the configuration for a mirror port PE 4-142
Table 4-43. Interfaces Switchport Parameters
Field Description