Filter
Top Products
Command Line Interface
4-120
4
Example
DHCP Commands
These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client. You can configure any VLAN interface to be automatically assigned
an IP address via DHCP.
DHCP Client
ip dhcp client-identifier
This command specifies the DCHP client identifier for the current interface. Use the
no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Console#show snmp user
EngineId: 01000000000000000000000000
User Name: steve
Authentication Protocol: md5
Privacy Protocol: des56
Storage Type: nonvolatile
Row Status: active
Console#
Table 4-4. SNMP User
Field Description
EngineId String identifying the engine ID.
User Name Name of user connecting to the SNMP agent.
Authentication Protocol The authentication protocol used with SNMPv3.
Privacy Protocol The privacy protocol used with SNMPv3.
Storage Type The storage type for this entry.
Row Status The row status of this entry.
Table 4-39. DHCP Clients
Command Function Mode Page
ip dhcp client-identifier Specifies the DHCP client identifier for this switch IC 4-120
ip dhcp restart client Submits a BOOTP or DHCP client request PE 4-121