Filter
Top Products
Command Line Interface
4-98
4
MAC ACLs
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
Table 4-35. MAC ACLs
Command Function Mode Page
access-list mac Creates a MAC ACL and enters configuration mode GC 4-98
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet type
MAC-ACL 4-99
show mac access-list Displays the rules for configured MAC ACLs PE 4-100
access-list mac
mask-precedence
Changes to the mode for configuring access control masks GC 4-101
mask Sets a precedence mask for the ACL rules MAC-Mask 4-102
show access-list mac
mask-precedence
Shows the ingress or egress rule masks for MAC ACLs PE 4-104
mac access-group Adds a port to a MAC ACL IC 4-104
show mac access-group Shows port assignments for MAC ACLs PE 4-105
map access-list mac Sets the CoS value and corresponding output queue for
packets matching an ACL rule
IC 4-105
show map access-list
mac
Shows CoS value mapped to an access list for an interface PE 4-106
match access-list mac Changes the 802.1p priority the priority of a frame
matching the defined rule (i.e., also called packet marking)
IC 4-106
show marking Displays the current configuration for packet marking PE 4-97