Filter
Top Products
Quality of Service
3-159
3
CLI – This example creates a policy map called “rd-policy,” sets the average
bandwidth the 1 Mbps, the burst rate to 1522 bps, and the response to drop any
violating packets.
Attaching a Policy Map to Ingress and Egress Queues
This function applies a policy map defined in the Policy Map, Policy Rule Settings
page to a particular interface.
You can only assign one policy map to an interface.
Command Attributes
•Ports — Specifies a port.
• Ingress/Egress — Applies the rule to ingress, and or egress traffic.
• Enabled — Check this to enable a policy map on a specified port.
Web – Click QoS, DiffServ, Service Policy Settings. Check Enabled to choose a
Policy Map for a port.
Figure 3-100. Service Policy Settings
CLI - This example applies a service policy to an ingress interface.
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 100000 1522 exceed-action drop
Console(config-pmap-c)#
Console(config)#interface ethernet 1/1 4-130
Console(config-if)#service-policy input rd_service 4-216
Console(config-if)#