Filter
Top Products
42 AR700 Series Router
C613-03087-00 Rev E
Figure 15: Sample output from the show cflash test command, when no test is running
To test a card, insert the card and enter:
enable cflash test start=startnumber end=endnumber
where startnumber and endnumber are positive integers within a cluster range.
The endnumber must be higher than the startnumber. Cluster ranges are
displayed in the output of the show cflash test command (Figure 15).
The test software will read the file allocation table and display a list of free
sectors. Sectors can be tested as single sectors or as a range. The test will consist
of a write/read/verify cycle.
To stop the test, use the command:
disable cflash test
To display the testing process while a test is in process, enter:
show cflash test
Figure 16: Sample output from the show cflash test command, when a test is running
If used when testing is not active, the previous command displays blank
cluster ranges on a compact flash card (Figure 15 on page 42).
Error messages are displayed when a file write fails. Failure could be due to the
card being removed or an error in the card.
Clusters available for testing
Ranges:
[42645--61944]
Number of free clusters = 19300
Number of ranges = 1
Number of used clusters = 42645
Test Progress
Starting cluster = 700
Ending cluster = 1700
Current cluster = 1185
Passed clusters number = 485
Passed sectors number = 1940
Failed clusters number = 0
Failed sectors number = 0
Used Clusters encountered = 0
Duration................ 4417 ms