AmbiCom WL250N-AR Network Router User Manual


 
2-3-4 Setup Procedures For ‘PPTP xDSL’:
PPTP xDSL requires two kinds of setting:
WAN interface setting (setup IP address) and PPTP setting (PPTP user name and password).
Select the type of how you obtain IP address from your service provider here. You can choose ‘Obtain an IP address
automatically’ (equal to DHCP, please refer to ‘Cable Modem’ section above), or ‘Use the following IP address’ (i.e. static IP
address).
WAN interface settings must be correctly set, or the Internet connection will fail even those settings of PPTP settings are
correct. Please contact your Internet service provider if you don’t know what you should fill in these fields.
PPTP settings section:
1
2
3
4
5
6
7
8
User ID (1): Please input user ID (user name) assigned by your Internet service provider here.
Password (2): Please input the password assigned by your Internet service provider here.
PPTP Gateway (3): Please input the IP address of PPTP gateway assigned by your Internet service provider here.
Connection ID (4): Please input the connection ID here. (Optional)
MTU (5): Please input the MTU value of your network connection here. (Use default value if you don’t know).
BEZEQ-ISRAEL (6): Check if you’re using the service provided by BEZEQ network in Israel.
Connection type (7): Please select the connection type of Internet connection you wish to use.
1. Continuous: Keep Internet connection alive, do not disconnect.
2. Connect on Demand: Only connects to Internet when there’s a connect attempt
12