Filter
Top Products
Customizing and Updating the PDU
80kW InfraStruXure PDU—Operation and Configuration 59
4. At the front of the PDU, connect the power cord’s individual wires:
a. If you have branch current monitoring installed, route the phase conductor through a current
sensor. If it is a three-phase cable, route the L1, L2, and L3 wires through a current sensor.
b. Connect the L1, L2, and L3 wires to the circuit breaker(s). The illustration below shows
single pole circuit breakers; however, you can also connect three-pole breakers.
c. Connect the neutral wire to the closest open termination point on the Neutral Bar (N).
d. Connect the ground wire to the closest open termination point on the Ground Bar (G).
G
N